Dell 5230dn Mono Laser Printer Service Manual - Page 119
Fuser unit, assembly removal on,
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Error code or message 920.02 Error contents Fuser warm-up failure Fuser type = 1 Description/Action The fuser hot roll fell to far below desired temperature while in standby control. 920.03 Fuser warm-up failure Fuser type = 1 The fuser hot roll is too cool while checking for slope change in standby. 920.04 Fuser warm-up failure Fuser type = 1 The fuser hot roll is too cool when heating to desired temperature after slope change within standby control only. Possible repair actions 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Diagnostic information 2-85