Dell 5230dn Mono Laser Printer Service Manual - Page 129

Error code or message 922.32 922.50 922.52 922.53 922.54 922.56 922.57 Error contents Fuser warm-up failure Fuser type = 2 Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. Description/Action The fuser hot roll does not reach operating temperature after increasing interpage gap. The fuser hot roll failed to reach target temperature. The fuser hot roll does not reach the "beginning lamp detection" parameter in the specified time. The fuser hot roll does reach the "final lamp detection" parameter but not in the specified time. The fuser hot roll has timed out and not reached "final lamp detection" during the specified time. The fuser hot roll did not reach operating temperature within new enhanced control. The fuser hot roll does not reach operating temperature after increasing interpage gap. Possible repair actions 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Check all connections on the fuser and LVPS card assembly. 4. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 5. Replace the LVPS card assembly if problem remains. Go to "System card assembly removal" on page 4-76 or "LVPS card assembly removal (5350dn, 5530dn, and T656)" on page 4-30. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. Diagnostic information 2-95