Dell 5230dn Mono Laser Printer Service Manual - Page 200
Leading edge, Trailing edge
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Step Check 7 Perform a print test. Does the problem remain? Skew Leading edge Yes Contact next highest level of tech support. No Problem solved. Trailing edge The printed image is not paralleled with both sides of the media. Step Check Yes 1 Check printer installation placement. Check the installation surface for irregularities. Check for damaged printer caster. Is the setup surface normal? Go to step 2. 2 Properly load media into the media tray assembly and Go to step 3. ensure all guides are set correctly. Properly install the media tray assembly into the printer. Re-print the defective image. Does the error continue? 3 Check for obstructions in the area of the media feed units. Are the media feed unit assembly free from any obstructions? Go to step 4. 4 Check the transfer roll assembly for contamination and Go to step 5. wear. Is the above component free of excess wear and contamination? No Correct the installation placement. Problem solved. Remove obstructions. Replace the transfer roll assembly. Go to "Transfer roll assembly removal" on page 4-80. 2-166 Service Manual