Dell 5230dn Mono Laser Printer Service Manual - Page 160
Sensor input lingering jam service check.
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Step Check Yes 20 Perform a print test and check the pick arm assembly. Go to step 21. Is the media properly picked and advanced out of the media tray? 21 Perform a print test and check the main motor assembly. Is the media properly transported and able to reach the sensor (input)? Go to step 22. 22 Perform a print test. Does the problem remain? Contact next highest level of tech support. No Replace the pick arm assembly. Go to "Operator panel door assembly removal (T656)" on page 4-49. Replace the main drive motor assembly. Go to "Output cover assembly removal" on page 4-54. Problem solved. Sensor (input) lingering jam service check. Use this procedure for the following jams: • 200.01 • 200.02 • 200.17 • 200.27 • 200.28 • 200.29 • 200.39 • 200.47 • 200.48 • 200.58 • 200.59 • 200.18 • 200.37 • 200.49 • 200.19 • 200.38 • 200.57 Step Check Yes 1 Check the media size setup and tray guides for all media trays. Go to step 2. Does the media size, in use, match the size set for all media trays? 2 Check the fuser unit assembly for obstructions. Is the above component free of obstructions? Remove obstructions. 3 Check the fuser unit assembly for excess wear and damage. Go to step 4. Is the above component free of excess wear and damage? 4 Check the sensor (input) for proper operation. 1. Enter the diagnostic mode Go to step 6. 2. Select Base sensor test 3. Observe the line item "input" Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. No Replace the media, or change the media size setup. Go to step 3. Replace the fuser unit assembly. Go to "Fuser unit assembly removal" on page 4-22. Go to step 5. 2-126 Service Manual