Dell 5230dn Mono Laser Printer Service Manual - Page 177

Step Check Yes No 4 Check the above sensor for proper connection. Is the above sensor connected properly? 5 Perform a print test using the output option. Does the error continue? Replace the stapler unit assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-183. Replace the output option. Replace the connection. Problem solved. Sensor (stapler pass through) static jam service check Step Check Yes No 1 Check the media path for partially fed or jammed media. Go to step 2. Is the media path free from partially fed or jammed media? Remove any prestaged or jammed media. 2 Check the sensor (stapler pass through) for proper operation. Go to step 4. Go to step 3. 1. Enter the diagnostic mode 2. Select Finisher sensor test 3. Select Sensor test 4. Select pass & media 5. Observe the line item "passthru" Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the stapler unit assembly. Replace the connection. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-183. 4 Perform a print test using the output option. Does the error continue? Replace the output Problem solved. option. Sensor (output pass through) late jam service check Step Check 1 Check the output option for proper installation. Is the above component properly installed? Yes Go to step 2. No Remove then reinstall the output option Diagnostic information 2-143