Dell 5230dn Mono Laser Printer Service Manual - Page 151
capacity input tray HCIT, pick arm bracket, assembly removal on, System card,
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Error code or message 985.07 Error contents Service engine RFID communications Description/Action Antenna is disconnected 990.00 990.02 Output option equipment check. Paperport failure Output option rear door not fully closed. Invalid paperport parameter 990.03 Paperport failure Invalid paperport protocol 990.04 Paperport failure Unsupported paperport command 990.06 Paperport failure Unknown page supervisor state 990.09 Paperport failure Paperport framing error 990.10 Paperport failure Paperport overrun error Possible repair actions 1. Check the RFID firmware card, RFID interface card, RFID cable, and RFID option for correct installation. Go to "High capacity input tray (HCIT) pick arm bracket assembly removal" on page 4-131. 2. Replace the RFID UHF option. Note: There can be no other connectivity options installed on printers that have the RFID UHF option installed. If any connectivity option is installed (other than the RFID interface card), a 985.xx error will occur Close the rear door on all output options. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Replace the system card assembly. Go to "System card assembly removal" on page 4-76. Diagnostic information 2-117