Dell 5230dn Mono Laser Printer Service Manual - Page 89
Tray roller
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Error code or message 244.17 244.18 244.19 244.33 244.34 244.35 244.36 244.37 244.39 244.40 Error contents Media tray pulled jam Pick retry timeout Source = Tray 4 Pick retry timeout Source = Tray 4 Tray 4 not ready Source = Tray 4 Empty tray pick attempted Source = Tray 4 Pick page received while POR not yet done. Source = Tray 4 Sensor (pass through) static jam Source = Tray 4 Sensor (pass through) late jam Source = Tray 4 Media tray pulled jam Source = Tray 4 Sensor (pass through) lingering jam Source = Tray 4 Description/Action A media tray above the source tray was pulled during the printing process. The engine timed out waiting for the tray 4 to report ready before the first pick attempt. The engine timed out waiting for the tray 4 to report ready before a pick retry attempt. Tray was not properly pushed into the machine. The pick arm attempted to pick with no media in the tray. Media remains on the sensor (input) during the warm up sequence. Media remains on the sensor (input) during the warm up sequence. The media is late reaching the sensor (pass through) within the specified time. A media tray above the source tray was pulled during the printing process. Media reached the sensor (pass through) within the specified time but did not clear it within the specified time. Possible repair actions 1. Remove all media present in media path. 2. Close all media trays. Turn the machine off/on. Turn the machine off/on. 1. Check the size sensing fingers on the media tray for damage 2. Replace the media tray assembly if problem remains. 3. Check the switch (media size) for proper connection. 4. Replace the switch (media size) if problem remains. Go to "Switch (media size) assembly removal" on page 4-74. 1. Check the media out actuator for damage. 2. Replace the media out actuator if problem remains. Go to "Tray roller catch assembly removal" on page 4-83. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-141. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-141. Go to sensor (pass through) late jam service check. See "Sensor (pass through) late jam service check" on page 2-139. 1. Remove all media present in media path. 2. Close all media trays. Go to sensor (pass through) lingering jam service check. See "Sensor (pass through) lingering jam service check." on page 2-140. Diagnostic information 2-55