Dell 5230dn Mono Laser Printer Service Manual - Page 174

Step Check Yes No 8 Perform a print test and check the pick arm assembly for the appropriate media tray. Is the media properly picked and advanced out of the appropriate media tray? Go to step 8. Replace the appropriate pick arm assembly. Go to "Operator panel door assembly removal (T656)" on page 4-49. 9 Perform a print test and check the main motor assembly. Go to step 9. Is the media properly transported through the pass through areas of the media trays? Replace the main drive motor assembly. Go to "Output cover assembly removal" on page 4-54. 10 Perform a print test using the appropriate input tray. Does the error continue? Replace the input Problem solved. option. Sensor (pass through) lingering jam service check. Use this procedure for the following jams: • 242.08 • 242.40 • 243.08 • 244.40 • 245.08 • 245.40 • 243.40 244.08 Step Check Yes 1 Check the media size setup and tray guides for all media Go to step 2. trays. Does the media size, in use, match the size set for all media trays? 2 Check the media tray pass through areas for obstructions. Go to step 3. Are the pass through areas in all the media trays free from obstructions? 3 Check the appropriate media tray sensor (pass through) for Go to step 5. proper operation. 1. Enter the diagnostic mode 2. Select Input tray tests 3. Sensor test 4. Select the appropriate tray number 3. Observe the line item "pass through" for the appropriate media tray Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. No Replace the media, or change the media size setup. Remove obstructions. Go to step 4. 2-140 Service Manual