Dell 5230dn Mono Laser Printer Service Manual - Page 79
size assembly removal
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Error code or message 242.52 242.33 242.34 242.35 242.36 242.37 242.39 242.40 Error contents Tray 2 pick motor overrun failure Source = Tray 2 Tray 2 not ready Source = Tray 2 Empty tray pick attempted Source = Tray 2 Pick page received while POR not yet done. Source = Tray 2 Sensor (pass through) static jam Source = Tray 2 Sensor (pass through) late jam Source = Tray 2 Media tray pulled jam Sensor (pass through) lingering jam Source = Tray 2 Description/Action The Pick motor encoder continues to detect pulses after the motor was turned off. Tray was not properly pushed into the machine. The pick arm attempted to pick with no media in the tray. Media remains on the sensor (input) during the warm up sequence. Media remains on the sensor (input) during the warm up sequence. The media is late reaching the sensor (pass through) within the specified time. A media tray above the source tray was pulled during the printing process. Media reached the sensor (pass through) within the specified time but did not clear it within the specified time. Possible repair actions 1. Check all connections on the pick arm assembly. 2. Check all connections on the system card assembly. 3. Replace the pick arm assembly if problem remains. Go to "Operator panel door assembly removal (T656)" on page 4-49. 1. Check the size sensing fingers on the media tray for damage 2. Replace the media tray assembly if problem remains. 3. Check the switch (media size) for proper connection. 4. Replace the switch (media size) if problem remains. Go to "Switch (media size) assembly removal" on page 4-74. 1. Check the media out actuator for damage. 2. Replace the media out actuator if problem remains. Go to "Tray roller catch assembly removal" on page 4-83. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-141. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-141. Go to sensor (pass through) late jam service check. See "Sensor (pass through) late jam service check" on page 2-139. 1. Remove all media present in media path. 2. Close all media trays. Go to sensor (pass through) lingering jam service check. See "Sensor (pass through) lingering jam service check." on page 2-140. Diagnostic information 2-45