Dell 5230dn Mono Laser Printer Service Manual - Page 126

Error code or message 922.06 Error contents Fuser warm-up failure Fuser type = 1 Description/Action The fuser hot roll did not reach operating temperature within new enhanced control. 922.07 Fuser warm-up failure Fuser type = 1 The fuser hot roll does not reach operating temperature after increasing interpage gap. 922.25 Fuser warm-up failure Fuser type = 2 The fuser hot roll failed to reach target departure. Possible repair actions 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Check all connections on the fuser and LVPS card assembly. 4. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 5. Replace the LVPS card assembly if problem remains. Go to "System card assembly removal" on page 4-76 or "LVPS card assembly removal (5350dn, 5530dn, and T656)" on page 4-30. 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Check all connections on the fuser and LVPS card assembly. 4. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 5. Replace the LVPS card assembly if problem remains. Go to "System card assembly removal" on page 4-76 or "LVPS card assembly removal (5350dn, 5530dn, and T656)" on page 4-30. 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensure the proper voltage fuser is installed in the machine. 3. Replace the fuser unit assembly if problem remains. Go to "Fuser unit assembly removal" on page 4-22. 2-92 Service Manual