Dell 5230dn Mono Laser Printer Service Manual - Page 166

Step Check 9 Perform a print test. Does the problem remain? Sensor (fuser output) static jam service check Use this procedure for the following jams: • 202.06 • 202.13 • 202.31 • 202.63 • 202.81 • 202.88 Yes Contact next highest level of tech support. No Problem solved. • 202.38 • 202.56 Step Check Yes No 1 Check the media path for partially fed or jammed media. Go to step 2. Is the media path free from partially fed or jammed media? Remove any prestaged or jammed media. 2 Check the sensor (fuser output) for proper operation. 1. Enter the diagnostic mode Go to step 4. Go to step 3. 2. Select Base sensor test 3. Observe the line item "input" Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the fuser unit assembly. Go to "Fuser unit assembly removal" on page 4-22. Replace the connection. 4 Perform a print test. Does the problem remain? Contact next highest level of tech support. Problem solved. 2-132 Service Manual