Dell 5230dn Mono Laser Printer Service Manual - Page 75

Error code or message 241.01 241.06 241.07 Error contents Pick motor control failure. Media tray 1 Description/Action The pick motor does not reach the proper operating speed at the specified time. Sensor (input) late jam Source = Tray 1 or MPF The media is late reaching the sensor (input) within the specified time. Pick motor load error Source = Media tray 1 The pick motor has failed or caused high mechanical load due to paper jam or bind. Possible repair actions 1. Remove all media present in media path. 2. Ensure media tray is not overfilled. 3. Check all connections on the pick arm assembly. 4. Check all connections on the system card assembly. 5. Replace the pick arm assembly if problem remains. Go to "Operator panel door assembly removal (T656)" on page 4-49. 6. Replace system card assembly if problem remains. Go to "System card assembly removal" on page 4-76. Go to sensor (input) late jam service check. See "Sensor (input) late jam service check." on page 2-123. 1. Remove all media present in media path. 2. Ensure media tray is not overfilled. 3. Check, clean or replace the pick rolls for wear and excess contamination. Go to "Pick roll assembly removal" on page 4-57. 4. Check all connections on the pick arm assembly. 5. Check all connections on the system card assembly. 6. Replace the pick arm assembly if problem remains. Go to "Operator panel door assembly removal (T656)" on page 4-49. 7. Replace system card assembly if problem remains. Go to "System card assembly removal" on page 4-76. Diagnostic information 2-41