Dell 5230dn Mono Laser Printer Service Manual - Page 201
Media damage
View all Dell 5230dn Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
Step Check 5 Check the aligner assembly for proper adjustment. Go to "Alignment assembly adjustment" on page 4-4. Does the problem remain? 6 Perform a print test. Does the problem remain? Media damage Leading edge Yes Go to step 6. Contact next highest level of tech support. No Replace the aligner assembly. Go to "Output cover assembly removal" on page 4-54. Problem solved. Trailing edge Step Check 1 Check printer installation placement. Check the installation surface for irregularities. Check for missing printer foot. Is the setup surface normal? 2 Check the media feed. Remove the media tray assembly. Properly load media in the media tray assembly. Properly install the media tray assembly in the printer. Re-print the defective image. Does the error continue? 3 Check the media condition. Load new, dry, recommended media. Re-print the defective image. Does the error continue? Yes Go to step 2. Go to step 3. Go to step 4. No Correct the installation placement. Problem solved. Problem solved. Diagnostic information 2-167