Dell 5230dn Mono Laser Printer Service Manual - Page 65

Error code or message 203.08 Error contents Redrive motor load error Description/Action The redrive motor assembly has failed or caused high mechanical load during the warm up sequence. 203.10 Redrive motor control failure. Media tray 1 The redrive motor does not reach the proper operating speed at the specified time. 203.18 Redrive motor assembly underspeed error. The redrive motor assembly does not rotate at the specified speed. 203.20 Redrive motor lost encoder failure The redrive motor is not reporting pulses back to the engine. Possible repair actions 1. Remove all media present in media path. 2. Ensure that upper redive assembly is properly installed. 3. Check all connections on the redrive motor assembly. 4. Check all connections on the system card assembly. 5. Replace the redrive motor assembly if problem remains. Go to "Redrive assembly removal" on page 4-63. 1. Remove all media present in media path. 2. Ensure that upper redive assembly is properly installed. 3. Check all connections on the redrive motor assembly. 4. Check all connections on the system card assembly. 5. Replace the redrive motor assembly if problem remains. Go to "Redrive assembly removal" on page 4-63. 1. Remove all media present in media path. 2. Ensure that upper redive assembly is properly installed. 3. Check all connections on the redrive motor assembly. 4. Check all connections on the system card assembly. 5. Replace the redrive motor assembly if problem remains. Go to "Redrive assembly removal" on page 4-63. 1. Check all connections on the redrive motor assembly. 2. Check all connections on the system card assembly. 3. Replace the redrive motor assembly if problem remains. Go to "Redrive assembly removal" on page 4-63. Diagnostic information 2-31