Epson FX-185 User Manual - Page 128
Chr$279, Tchr$12
View all Epson FX-185 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
off, either by changing DIP switches or by sending the printer ASCII codes as summarized below. Switch 2-2 When on; activates the beeper; when off, deactivates it Switch 1-3 When off, makes the paper-out sensor active; when on, deactivates it Switch 2-3 When off, turns the skip-over-perforation feature OFF; when on, produces an automatic 1-inch skip over every perforation Check to see if you want to reset any switches before going on to Chapter 9. Here are the commands we covered in this chapter: CHR$(12) Produces a form feed; CHR$(140) is the alternate, high-order version CHR$(27)"C"CHR(0)CHR$(n) Sets the form length to n inches, where n is 1 - 22 CHR$(27)"C"CHR$(n) Sets the form length to n lines, where n is 1 - 127 CHR$(27)"N"CHR$(n) Turns the skip-over-perforation feature ON, set to n lines, where n is 1 to less than the current form length in lines. Is cancelled by CHR$(27)"@" and CHR$(27)"C" as well as CHR$(27)"O" CHR$(27)"O" Turns the automatic skip-over-perforation feature OFF CHR$(27)"8" Turns the paper-out sensor OFF CHR$(27)"9" Used in conjunction with CHR$(27)"8", turns the paper-out sensor back ON CHR$(27)"@" The Reset Code resets the form length to 11 inches, the top of form to the current line, and the skip-over-perforation to the DIP switch setting 111