HP 635n HP Jetdirect Print Server Administrator's Guide - Page 136
IPv4
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Table 8-5 TCP/IP Configuration Information (continued) Message Description IPv4 Section The following table includes items displayed under the IPv4 section of the configuration page. Table 8-6 IPv4 Section Message IP ADDRESS: SUBNET MASK: DEFAULT GATEWAY: CONFIG BY: BOOTP SERVER: or DHCP SERVER: Description The Internet Protocol version 4 (IPv4) address assigned to the HP Jetdirect print server. This is a required entry for operation of the print server on a TCP/IP network. During initialization, a temporary value 0.0.0.0 is displayed. After two minutes, a default IP address 169.254/16 or 192.0.0.192 is assigned. Not Specified: Indicates that an IP address is not assigned or the value is zero. The IPv4 subnet mask configured on the HP Jetdirect print server. During initialization, a temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the print server may automatically assign a usable default value. Not Specified: Indicates that a subnet mask is not configured. The IPv4 address of the gateway used when sending packets off the local network. Only one default gateway may be configured. During initialization, a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the Jetdirect print server is used. Not Specified: Indicates that a default gateway is not configured. Identifies how the HP Jetdirect print server obtained its IPv4 configuration: BOOTP: Automatic configuration through a BOOTP server. BOOTP/TFTP: Automaticautomatic configuration through a BOOTP server and TFTP configuration file. DHCP: Automatic configuration through a DHCP server DHCP/TFTP: Automatic configuration through a DHCP server and TFTP configuration file. RARP: Automatic configuration through the Reverse Address Resolution Protocol. USER SPECIFIED: Manual configuration through Telnet, the printer's control panel, HP Web Jetadmin, embedded Web server, or other method. DEFAULT IP: The default IP address was assigned. This address may not be a valid address for your network. AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a linklocal network, this address should be valid. NOT CONFIGURED: The print server was not configured with IP parameters. Verify that TCP/IP is enabled, or check for error status. Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the IP address of the system that responds to the HP Jetdirect print server's request for automatic TCP/IP configuration over the network. Not Specified: Indicates that the configuration server's IP address could not be determined or was set to zero in the response packet. 126 Chapter 8 HP Jetdirect Configuration Pages ENWW