HP 635n HP Jetdirect Print Server Administrator's Guide - Page 57
Telnet Commands and Parameters continued
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Table 3-3 Telnet Commands and Parameters (continued) ipsec-config Use this command to disable IPsec, if it is enabled on the print server. IPsec cannot be enabled by this command; if IPsec is enabled, its status will be "read only". 0: Disable IPsec, if it is enabled. 1: (Read Only) Indicates IPsec is enabled. Use the embedded Web server to enable IPsec. ip IP address for the print server, in dotted notation. For example: ip-config manual ip 192.168.45.39 where ip-config specifies manual configuration and ip manually sets the IP address 192.168.45.39 on the print server. Specifying 0.0.0.0 clears the IP address. If you exit and save a new IP address, it must be specified on the next Telnet connection. subnet-mask default-gw Config Server TFTP Server TFTP Filename domain-name pri-dns-svr sec-dns-svr pri-wins-svr sec-wins-svr A value (in dotted notation) that identifies the network and host portions of an IP address in received messages. For example, subnet-mask 255.255.255.0 stores the subnet mask value 255.255.255.0 on the print server. The value 0.0.0.0 disables the subnet mask. The IP address of a default gateway, in dotted notation. For example, default-gw 192.168.40.1 assigns 192.168.40.1 as the IP address of the default gateway for the print server. NOTE If the HP Jetdirect print server is configured by DHCP and you manually change the subnet mask or the default gateway address, you should manually change the print server's IP address. This will release the DHCPassigned address back to the DHCP IP address pool. (Read-only parameter) The IP address of the server (such as a BOOTP or DHCP server) that last configured the IP address on the HP Jetdirect print server. (Read-only parameter) The IP address of the TFTP server that provided TFTP parameters to the HP Jetdirect print server. (Read-only parameter) The path and TFTP filename on the TFTP server. For example, hpnp/printer1.cfg The domain name for the device. For example, domain-name support.hp.com assigns support.hp.com as the domain name. The domain name does not include the host name; it is not the Fully Qualified Domain Name (such as printer1.support.hp.com). IP address of the primary DNS (Domain Name System) server. IP address of a secondary DNS server to use if the primary DNS server is unavailable. The IP address of the primary Windows Internet Naming Service (WINS) server, in dotted notation. The IP address of the secondary Windows Internet Naming Service (WINS) server, in dotted notation. ENWW IPv4 Configuration 47