HP 635n HP Jetdirect Print Server Administrator's Guide - Page 63

Table 3-3 Telnet Commands and Parameters (continued) CAUTION Disabling SNMP will disable all SNMP agents (SNMP v1, v2, v3) as well as communications with management applications, such as HP Web Jetadmin. In addition, firmware upgrades through current HP downloading utilities will be disabled. get-cmnty-name set-cmnty-name default-get-cmnty SNMP Traps auth-trap trap-dest IPX/SPX ipx-config ipx-unitname Address Specifies a password that determines which SNMP GetRequests the HP Jetdirect print server will respond to. This is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factorydefault. The community name must be ASCII characters. The maximum length is 255 characters. Specifies a password that determines which SNMP SetRequests (control functions) the HP Jetdirect print server will respond to. The community name of an incoming SNMP SetRequest must match the print server's "set community name" for the print server to respond. (For additional security, you may limit configuration access through the print server's host access list.) Community names must be ASCII characters. The maximum length is 255 characters. Enables or disables the default Get community name. 0 disables, 1 (default) enables. Disabling this parameter may prohibit communications with SNMP management applications. Configures the print server to send (on) or not send (off) SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. 0 is off, 1 (default) is on. Enters a host IP address into the HP Jetdirect print server's SNMP trap destination list. The command format is: trap-dest: ip-address [community name] [port number] The default community name is 'public'; the default SNMP port number is '162'. The port number cannot be specified without a community name. To delete the table, use 'trap-dest: 0'. If the list is empty, the print server does not send SNMP traps. The list may contain up to three entries. The default SNMP Trap Destination List is empty. To receive SNMP traps, the systems listed on the SNMP trap destination list must have a trap daemon to listen to those traps. Enables or disables IPX/SPX protocol operation on the print server. 0 disables, 1 (default) enables. For example, ipx-config 0 will disable IPX/SPX operation. (Print Server Name) A user-assigned alphanumeric name assigned to the print server (31 characters maximum). By default, the name will be NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware address. (Read-only parameter) Identifies the IPX network and node numbers detected on the network, in the form NNNNNNNN:hhhhhhhh (hexadecimal), where NNNNNNNN is the network number and hhhhhhhh is the LAN hardware address of the print server. ENWW IPv4 Configuration 53