HP 635n HP Jetdirect Print Server Administrator's Guide - Page 55

Command Line Interface (Default) Using the Telnet command line interface, you can set configuration parameters using the following procedures: NOTE During a Telnet session, enter ? to view available configuration parameters, the correct command format, and a list of commands. To list additional (or advanced) commands, enter the command advanced before entering ?. To display current configuration information, enter /. 1 At the Telnet prompt ">" type: : then press Enter, where refers to the configuration parameter you are defining, and refers to the definitions you are assigning to that parameter. Each parameter entry is followed by a carriage return. See Table 3-3 Telnet Commands and Parameters for configuration parameters. 2 Repeat the previous step to set any additional configuration parameters. 3 When you have finished typing the configuration parameters, type exit or quit (depending on your system). When prompted whether to save settings that you have changed, enter Y (default) for Yes, or N for No. If you enter save instead of exit or quit, you will not be prompted to save settings. Telnet Commands and Parameters. Table 3-3 Telnet Commands and Parameters lists the available Telnet commands and parameters. NOTE If a parameter is supplied dynamically (for example, from a BOOTP or DHCP server), its value cannot be changed using Telnet without first setting Manual configuration. To set Manual configuration, see the ip-config command. Whenever you are manually changing an IP address, you should also reconfigure the subnet mask and default gateway at the same time. Table 3-3 Telnet Commands and Parameters Command User Control Commands ? / menu advanced Description Displays the Help and Telnet commands. Displays current values. Displays the Menu Interface for access to configuration parameters. Enables the Advanced commands. Help (?) will include the Advanced commands in the list. ENWW IPv4 Configuration 45