HP 635n HP Jetdirect Print Server Administrator's Guide - Page 60
Specifies the IP multicast Time To Live TTL setting for Service Location Protocol
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Table 3-3 Telnet Commands and Parameters (continued) network. To enable this feature, set a value from 1 to 1440 minutes. Set 0 to disable this feature. mdns-config Enables or disables Multicast Domain Name System (mDNS) services. 0 disables, 1 (default) enables. mDNS is typically used on small networks for IP address and name resolution (through UDP port 5353) where a conventional DNS server is not available. For mDNS operation, Multicast IPv4 must be enabled. mdns-service-name Specifies an alphanumeric string of up to 64 ASCII characters assigned to this device or service. This name is persistent and is used to resolve a particular device or service if socket information (such as the IP address) changes from session to session. Apple mDNS will display this service. The default service name is the printer model and the LAN Hardware (MAC) address. mDNS Domain Name (Read-only parameter) Specifies the mDNS domain name assigned to the device, in the form .local. If a user-specified host name has not been assigned, the default host name NPIxxxxxx is used, where xxxxxx are the last 6 digits of the LAN hardware (MAC) address. mdns-pri-svc ttl-slp ipv4-multicast idle-timeout Specifies the mDNS highest priority service to use for printing.To set this parameter, choose one of the following printing option numbers: 1: Port 9100 printing 2: IPP port printing 3: The default LPD raw queue 4: The default LPD text queue 5: The default LPD auto queue 6: The default LPD binps (binary postscript) queue 7 through 12: If user-specified LPD queues are defined, corresponds to user-specified LPD queues 5 through 10. The default selection will depend on the printer, typically port 9100 printing or LPD binps. Specifies the IP multicast "Time To Live" (TTL) setting for Service Location Protocol (SLP) packets. The default value is 4 hops (the number of routers from the local network). The range is 1-15. When set to a -1, multicast capability is disabled. Enables or disables the receipt and transmission of IP version 4 multicast packets by the print server. 0 disables, 1 (default) enables. NOTE If this parameter is disabled, other protocols that use multicast protocols, such as mDNS and SLP, may also be disabled without notification. An integer (1to 3600) that specifies the number of seconds an idle print data connection is allowed to remain open. For example, idle-timeout 120 assigns 120 seconds as the desired idle timeout value. The default is 270 seconds. If set to 0, the connection will not terminate and other hosts will not be able to make a connection. 50 Chapter 3 TCP/IP Configuration ENWW