HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 105
sntp server
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Clock Commands sntp server The sntp server Global Configuration mode command configures the device to use the Simple Network Time Protocol (SNTP) to request and accept SNTP traffic from a specified server. To remove a server from the list of SNTP servers, use the no form of this command. Syntax sntp server {ip-address | hostname}[poll] [key keyid] no sntp server host Parameters n ip-address - IP address of the server. n hostname - Hostname of the server. (Range: 1-158 characters) n poll - Enable polling. n keyid - Authentication key to use when sending packets to this peer. (Range: 1-4294967295) Default Setting No servers are defined. Command Mode Global Configuration mode Command Usage Up to 8 SNTP servers can be defined. Use the sntp unicast client enable Global Configuration mode command to enable predefined unicast clients globally. To enable polling you should also use the sntp unicast client poll Global Configuration mode command for global enabling. Polling time is determined by the sntp client poll timer Global Configuration mode command. Example The following command configures the device to accept SNTP traffic from the server on 192.1.1.1. Console(config)# sntp server 192.1.1.1 HP PC Blade Switch CLI Reference Guide www.hp.com 6-15