HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 213
Port Monitor Commands, port monitor
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
17 Port Monitor Commands port monitor The port monitor Interface Configuration mode command starts a port monitoring session. To stop a port monitoring session, use the no form of this command. Syntax port monitor src-interface [rx | tx] no port monitor src-interface Parameters n src-interface - Valid Ethernet port. (Full syntax: port) n rx - Monitors received packets only. n tx - Monitors transmitted packets only. Default Setting Monitors both received and transmitted packets. No port monitors are configured by default. Command Mode Interface Configuration (Ethernet) mode Command Usage This command enables traffic on one port to be copied to another port, or between the source port (src-interface) and a destination port (port being configured). The following restrictions apply to ports configured as destination ports: n The port cannot be already configured as a source port. n The port cannot be a member in a port-channel. n An IP interface is not configured on the port. n GVRP is not enabled on the port. n The port is not a member of a VLAN, except for the default VLAN (will automatically be removed from the default VLAN). n The following restrictions apply to ports configured to be source ports: n The port cannot be already configured as a destination port. HP PC Blade Switch CLI Reference Guide www.hp.com 17-1