HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 69
Address Table Commands, bridge address
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
5 Address Table Commands bridge address The bridge address Interface Configuration (VLAN) mode command adds a MAC-layer station source address to the bridge table. To delete the MAC address, use the no form of this command. Syntax bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent | delete-on-reset | delete-on-timeout | secure] no bridge address [mac-address] Parameters n mac-address - A valid MAC address. n interface - A valid Ethernet port. n port-channel-number - A valid port-channel number. n permanent - The address can only be deleted by the no bridge address command. n delete-on-reset - The address is deleted after reset. n delete-on-timeout - The address is deleted after "age out" time has expired. n secure - The address is deleted after the port changes mode to unlock learning (no port security command). This parameter is only available when the port is in the learning locked mode. Default Setting No static addresses are defined. The default mode for an added address is permanent. Command Mode Interface Configuration (VLAN) mode Command Usage Using the no form of the command without specifying a MAC address deletes all static MAC addresses belonging to this VLAN). On interfaces that have an IP address configured, use the command "port security routed secure address" to configure an address with "secure" option. HP PC Blade Switch CLI Reference Guide www.hp.com 5-1