HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 405
switchport trunk native vlan, Port <Number>, extension, separated-bridge exist
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
VLAN Commands switchport trunk native vlan The switchport trunk native vlan Interface Configuration mode command defines the native VLAN when the interface is in trunk mode. To return to the default configuration, use the no form of this command. Syntax switchport trunk native vlan vlan-id no switchport trunk native vlan Parameters n vlan-id- Specifies the ID of the native VLAN. Default Setting This command has no default configuration. Command Mode Interface Configuration (Ethernet, port-channel) mode Command Usage The command adds the port as a member in the VLAN. If the port is already a member in the VLAN (not as a native), it should be first removed from the VLAN. . When MSTP-to-RSTP is enabled (enabled by default) attempting to put any switch port into trunk or general mode will cause the following error message: Port , extension separated-bridge exist. This feature must be disabled before the switch can support these modes. Please see spanning-tree mst mstp-rstp for more information. Example The following command configures VLAN number 123 as the native VLAN when Ethernet port e42 is in trunk mode. Console(config)# interface ethernet e42 Console(config-if)# switchport trunk native vlan 123 HP PC Blade Switch CLI Reference Guide www.hp.com 28-9