HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 40
dot1x single-host-violation, dot1x single-host-violation {forward | discard | discard-shutdown} [trap
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
802.1x Commands dot1x single-host-violation The dot1x single-host-violation Interface Configuration mode command configures the action to be taken, when a station whose MAC address is not the supplicant MAC address, attempts to access the interface. Use the no form of this command to return to default. Syntax dot1x single-host-violation {forward | discard | discard-shutdown} [trap seconds] no port dot1x single-host-violation Parameters n forward - Forwards frames with source addresses that are not the supplicant address, but does not learn the source addresses. n discard - Discards frames with source addresses that are not the supplicant address. n discard-shutdown - Discards frames with source addresses that are not the supplicant address. The port is also shut down. n trap - Indicates that SNMP traps are sent. n seconds - Specifies the minimum amount of time in seconds between consecutive traps. (Range: 1-1000000) Default Setting Frames with source addresses that are not the supplicant address are discarded. No traps are sent. Command Mode Interface Configuration (Ethernet) mode Command Usage The command is relevant when multiple hosts is disabled and the user has been successfully authenticated. Example The following command forwards frames with source addresses that are not the supplicant address and sends consecutive traps at intervals of 100 seconds. Console(config-if)# dot1x single-host-violation forward trap 100 2-20 www.hp.com HP PC Blade Switch CLI Reference Guide