HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 145

GVRP Commands garp timer The garp timer Interface Configuration (Ethernet, port-channel) mode command adjusts the values of the join, leave, and leaveall timers of GARP applications. To return to the default configuration, use the no form of this command. Syntax garp timer {join | leave | leaveall} timer_value no garp timer Parameters n {join | leave | leaveall} - Indicates the type of timer. n timer_value - Timer values in milliseconds in multiples of 10. (Range: 10-2147483647) Default Setting Following are the default timer values: n Join timer - 200 milliseconds n Leave timer - 600 milliseconds n Leavall timer - 10000 milliseconds Command Mode Interface configuration (Ethernet, port-channel) mode Command Usage The following relationship must be maintained between the timers: n Leave time must be greater than or equal to three times the join time. n Leave-all time must be greater than the leave time. n Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on Layer 2-connected devices, the GARP application will not operate successfully. Example In the following example, the leave timer for Ethernet port e45 is set to 900 milliseconds. Console(config)# interface ethernet e45 Console(config-if)# garp timer leave 900 HP PC Blade Switch CLI Reference Guide www.hp.com 9-3