HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 73
bridge multicast forbidden address, Syntax, Parameters, Default Setting, Command Modes, Command Usage
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Address Table Commands bridge multicast forbidden address The bridge multicast forbidden address Interface Configuration (VLAN) mode command forbids adding a specific multicast address to specific ports. Use the no form of this command to return to the default configuration. Syntax bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add | remove} {ethernet interface-list | port-channel port-channel-number-list} no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} Parameters n add -Defines the port as forbidden. Forbidden ports are not included the Multicast group, even if IGMP snooping designated the port to join a Multicast group. n remove - Removes ports from the Forbidden Port list. n mac-multicast-address - A valid MAC multicast address. n ip- multicast-address - A valid IP multicast address. n interface-list - Separate nonconsecutive Ethernet ports with a comma and no spaces; hyphen is used to designate a range of ports. n port-channel-number-list - Separate nonconsecutive valid port-channels with a comma and no spaces; a hyphen is used to designate a range of port-channels. Default Setting No forbidden addresses are defined. Command Modes Interface Configuration (VLAN) mode Command Usage Before defining forbidden ports, the multicast group should be registered. Example The following command forbids MAC address 0100.5e02.0203 on port e9 within VLAN 1. Console(config)# interface vlan 1 Console(config-if)# bridge multicast address 0100.5e02.0203 Console(config-if)# bridge multicast forbidden address 0100.5e02.0203 add ethernet e9 HP PC Blade Switch CLI Reference Guide www.hp.com 5-5