HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 167
arp
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
IP Addressing Commands arp The arp Global Configuration mode command adds a permanent entry in the Address Resolution Protocol (ARP) cache. To remove an entry from the ARP cache, use the no form of this command. Syntax arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel number} no arp ip_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel number} Parameters n ip_addr - Valid IP address or IP alias to map to the specified MAC address. n hw_addr - Valid MAC address to map to the specified IP address or IP alias. n interface-number - Valid Ethernet port. n vlan-id - Valid VLAN number. n port-channel number. - Valid port-channel number. Default Setting This command has no default configuration. Command Mode Global Configuration mode Command Usage The software uses ARP cache entries to translate 32-bit IP addresses into 48-bit hardware addresses. Because most hosts support dynamic resolution, static ARP cache entries do not generally have to be specified. Example The following command adds IP address 198.133.219.232 and MAC address 00:00:0c:40:0f:bc to the ARP table. Console(config)# arp 198.133.219.232 00:00:0c:40:0f:bc ethernet e1 HP PC Blade Switch CLI Reference Guide www.hp.com 11-5