HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 124
duplex, duplex {half | full}, no duplex
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Ethernet Configuration Commands duplex The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex operation of a given Ethernet interface when not using auto-negotiation. To restore the default configuration, use the no form of this command. Syntax duplex {half | full} no duplex Parameters n half - Forces half-duplex operation n full - Forces full-duplex operation Default Setting The interface is set to full duplex. Command Mode Interface Configuration (Ethernet) mode Command Usage When configuring a particular duplex mode on the port operating at 10/100 Mbps, disable the auto-negotiation on that port. Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps. Example The following command configures the duplex operation of Ethernet port e42 to full duplex operation. Console(config)# interface ethernet e42 Console(config-if)# duplex full 8-6 www.hp.com HP PC Blade Switch CLI Reference Guide