HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 404
switchport trunk allowed vlan, remove, Port <Number>, extension, separated-bridge exist
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 404 highlights
VLAN Commands switchport trunk allowed vlan The switchport trunk allowed vlan Interface Configuration mode command adds or removes VLANs to or from a trunk port. Syntax switchport trunk allowed vlan {add vlan-list | remove vlan-list} Parameters n add vlan-list - List of VLAN IDs to be added. Separate nonconsecutive VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs. n remove vlan-list - List of VLAN IDs to be removed. Separate nonconsecutive VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs. Default Setting This command has no default configuration. Command Mode Interface Configuration (Ethernet, port-channel) mode Command Usage . When MSTP-to-RSTP is enabled (enabled by default) attempting to put any switch port into trunk or general mode will cause the following error message: Port , extension separated-bridge exist. This feature must be disabled before the switch can support these modes. Please see spanning-tree mst mstp-rstp for more information. Example The following command adds VLANs 1, 2, 5 to 6 to the allowed list of Ethernet port e42. Console(config)# interface ethernet e42 Console(config-if)# switchport trunk allowed vlan add 1-2,5-6 28-8 www.hp.com HP PC Blade Switch CLI Reference Guide