HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 72

Address Table Commands bridge multicast address The bridge multicast address Interface Configuration (VLAN) mode command registers a MAC-layer multicast address in the bridge table and statically adds ports to the group. To unregister the MAC address, use the no form of this command. Syntax bridge multicast address {mac-multicast-address | ip-multicast-address} bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove] {ethernet interface-list | port-channel port-channel-number-list} no bridge multicast address {mac-multicast-address | ip-multicast-address} Parameters n add - Adds ports to the group. If no option is specified, this is the default option. n remove - Removes ports from the group. n mac-multicast-address - A valid MAC multicast address. n ip- multicast-address - A valid IP multicast address. n interface-list - Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen is used to designate a range of ports. n port-channel-number-list - Separate nonconsecutive port-channels with a comma and no spaces; a hyphen is used to designate a range of ports. Default Setting No multicast addresses are defined. Command Mode Interface configuration (VLAN) mode Command Usage If the command is executed without add or remove, the command only registers the group in the bridge database. Static multicast addresses can only be defined on static VLANs. Examples The following command registers the MAC address: Console(config)# interface vlan 1 Console(config-if)# bridge multicast address 01:00:5e:02:02:03 The following command registers the MAC address and adds ports statically. Console(config)# interface vlan 1 Console(config-if)# bridge multicast address 01:00:5e:02:02:03 add ethernet e1-e9 5-4 www.hp.com HP PC Blade Switch CLI Reference Guide