HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 403
switchport access vlan, dynamic}, Port <Number>, extension, separated-bridge exist
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
VLAN Commands switchport access vlan The switchport access vlan Interface Configuration mode command configures the VLAN ID when the interface is in access mode. To return to the default configuration, use the no form of this command. Syntax switchport access vlan {vlan-id | dynamic} no switchport access vlan Parameters n vlan-id - Specifies the ID of the VLAN to which the port is configured. n dynamic -Indicates that the port is assigned to a VLAN based on the source MAC address of the host connected to the port. Default Setting Odd ports 1-41, 42, 45, and 46 are all in VLAN 1. The remaining ports are in VLAN 2. Command Mode Interface configuration (Ethernet, port-channel) mode Command Usage The command automatically removes the port from the previous VLAN and adds it to the new VLAN. . When MSTP-to-RSTP is enabled (enabled by default) attempting to put any switch port into trunk or general mode will cause the following error message: Port , extension separated-bridge exist. This feature must be disabled before the switch can support these modes. Please see spanning-tree mst mstp-rstp for more information. Example The following command configures Ethernet port e42 in access mode to be member of VLAN 23. Console(config)# interface ethernet e42 Console(config-if)# switchport access vlan 23 HP PC Blade Switch CLI Reference Guide www.hp.com 28-7