HP BladeSystem bc2800 Command Line Interface Reference Guide HP BladeSystem PC - Page 197
permit (Management), permit, ethernet, port-channel, service, permit ip-source, telnet
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
Management ACL Commands permit (Management) The permit Management Access-List Configuration mode command defines a permit rule. Syntax permit [ethernet interface-number | vlan vlan-id | port-channel port-channel-number] [service service] permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel port-channel-number | ] [service service] Parameters n interface-number - A valid Ethernet port number. n vlan-id - A valid VLAN number. n port-channel-number - A valid port channel index. n ip-address - A valid source IP address. n mask - A valid network mask of the source IP address. n prefix-length - Number of bits that comprise the source IP address prefix. The prefix length must be preceded by a forward slash (/). (Range: 0-32) n service - Service type. Possible values: telnet, ssh, http, https and snmp. Default Setting If no permit rule is defined, the default is set to deny. Command Mode Management Access-list Configuration mode Command Usage Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the appropriate interface. The system supports up to 128 management access rules. Example The following command permits all ports in the mlist access list. Console(config)# management access-list mlist Console(config-macl)# permit HP PC Blade Switch CLI Reference Guide www.hp.com 14-3