HP Z600 HP Z600 Workstation Maintenance and Service Guide - Page 146
Installing a PCIe card,
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Installing a PCIe card 1. Disconnect power from the workstation (see Predisassembly procedures on page 73). 2. Remove the side access panel (see Removing the side access panel on page 75). NOTE: An expansion card support is built into the side access panel. When the panel is removed, the card support is removed, allowing access to the expansion cards. 3. Select the desired expansion card slot for the PCIe card. (See Choosing an expansion card slot on page 132 for help in selecting a slot.) 4. Push the expansion card retention clamp levers down on the outside of the chassis to release the retention clamp as shown in the following figure . Figure 5-77 Removing the slot cover 5. Remove the PCI slot cover by pulling it up, out of the chassis 2. TIP: Grasp the slot cover between two fingers-one from the inside of the chassis, and one from the outside. 134 Chapter 5 Replacing components ENWW