HP Z600 HP Z600 Workstation Maintenance and Service Guide - Page 71

Setting the Side access panel sensor protection level To set the Side access panel sensor protection level: 1. Power on or restart the workstation. 2. As soon as the workstation is powered on, press and hold the F10 key until you enter the Computer Setup (F10) Utility. Press Enter to bypass the title screen, if necessary. NOTE: If you do not press the F10 key at the appropriate time, you must restart the workstation, and then press and hold the F10 key again to access the Computer Setup (F10) Utility. If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it. 3. Select Security>Smart Cover>Cover Removal Sensor, and follow the onscreen instructions. 4. Before exiting, select File>Save Changes and Exit. Side access panel solenoid lock The side access panel solenoid locks the side access panel to the chassis. The solenoid is controlled by a local or remote signal. To lock the solenoid, set a password for the solenoid lock in the Computer Setlup (F10) Utility. To unlock the solenoid, remove the solenoid lock password in the Computer Setup (F10) Utility. The solenoid lock FailSafe Key-available from HP-is is a device for manually disabling the solenoid lock. You will need the FailSafe Key in case of forgotten password, power loss, or workstation malfunction. Cable lock (optional) To prevent theft, the rear chassis panel of the workstation accommodates a keyed cable lock. This cable lock attaches to the chassis and secures it to the work area. (See Rear panel components on page 7 for component locations.) ENWW Workstation management 59