HP Z600 HP Z600 Workstation Maintenance and Service Guide - Page 95

Upper front bezel This section describes how to remove and replace the upper front bezel. Removing the upper front bezel 1. Disconnect power from the workstation (see Predisassembly procedures on page 73). 2. Remove the side access panel (see Removing the side access panel on page 75). 3. Remove the right side panel (see Removing the right side panel on page 78). 4. Remove the screw from the upper front bezel as shown in the following figure. Figure 5-11 Removing the upper front bezel 5. Rotate the bezel out and down to remove it from the chassis 2. Installing the upper front bezel To install the upper front bezel, place the bezel on the chassis and install the screw. ENWW Removing and installing components 83