HP xw3400 HP xw3400 Workstation - Service and Technical Reference Guide - Page 119
Numeric Codes and Text Messages continued - ram
View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Table C-1 Numeric Codes and Text Messages (continued) Control panel message Description Recommended action RTC (real-time clock) battery may need to be replaced. See the Hardware Reference Guide on the Documentation and Diagnostics CD for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement. 163-Time & Date Not Set CMOS jumper may not be properly installed. Check for proper placement of the CMOS jumper if applicable. 164-MemorySize Error Memory amount has changed since the last Press the F1 key to save the memory changes. boot (memory added or removed). 164-MemorySize Error Memory configuration incorrect. 1. Run Computer Setup or Windows utilities. 2. Make sure the memory module(s) are installed properly. 3. If third-party memory has been added, test using HP-only memory. 4. Verify proper memory module type. 201-Memory Error RAM failure. 1. Run Computer Setup or Windows utilities. 2. Ensure memory modules are correctly installed. 3. Verify proper memory module type. 4. Remove and replace the identified faulty memory module(s). 5. If the error persists after replacing memory modules, replace the system board. 213-Incompatible Memory Module in Memory Socket(s) X, X, ... A memory module in memory socket identified 1. in the error message is missing critical SPD information, or is incompatible with the 2. chipset. 3. Verify proper memory module type. Try another memory socket. Replace DIMM with a module conforming to the SPD standard. 214-DIMM Configuration Warning Populated DIMM Configuration is not optimized. Rearrange the DIMMs so that each channel has the same amount of memory. 219-ECC Memory Module Detected ECC Modules not supported on this Platform Recently added memory module(s) support ECC memory error correction. 1. If additional memory was recently added, remove it to see if the problem remains. 2. Check product documentation for memory support information. 301-Keyboard Error Keyboard failure. 1. Reconnect keyboard with workstation turned off. 2. Check connector for bent or missing pins. 3. Ensure that none of the keys are depressed. 4. Replace keyboard. ENWW POST numeric codes and text messages 109