HP xw3400 HP xw3400 Workstation - Service and Technical Reference Guide - Page 94
Fan shroud
View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Fan shroud 1. Prepare the workstation for disassembly (Preparation for disassembly on page 59). 2. Remove the access panel and rotate the workstation so the system board is parallel to the table to make it easier to work on (Access panel on page 61). 3. Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard drives. 4. Lift the shroud straight up (1) about 5-mm (3/16-in) before pulling it into the chassis (2) to remove it. NOTE: To install the shroud, reverse the removal process. 84 Chapter 7 Removal and replacement procedures ENWW
Fan shroud
1
.
Prepare the workstation for disassembly (
Preparation for disassembly
on page
59
).
2
.
Remove the access panel and rotate the workstation so the system board is parallel to the table to
make it easier to work on (
Access panel
on page
61
).
3
.
Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard
drives.
4
.
Lift the shroud straight up (1) about 5-mm (3/16-in) before pulling it into the chassis (2) to remove it.
NOTE:
To install the shroud, reverse the removal process.
84
Chapter
7
Removal and replacement procedures
ENWW