HP xw3400 HP xw3400 Workstation - Service and Technical Reference Guide - Page 99
Speaker, Remove the speaker by lifting it up 2 and out of the retaining clips.
View all HP xw3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Speaker 1. Prepare the workstation for disassembly (Preparation for disassembly on page 59). 2. Remove the access panel and rotate the workstation so the system board is parallel to the table to make it easier to work on (Access panel on page 61). 3. Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard drives. 4. Remove the shroud from the chassis (Fan shroud on page 84). 5. Disconnect the speaker wire from the system board connector. 6. Remove the two screws (1) that secure the speaker to the chassis. 7. Remove the speaker by lifting it up (2) and out of the retaining clips. To install the speaker, reverse the removal procedures making sure that the speaker wire is at the upper left of the speaker when viewed from inside the chassis. ENWW Speaker 89