Icom IC-9100 Instruction Manual - Page 10

1 PANEL DESCRIPTION ■ Front panel q !2 !1 w e r t y u i o !0 q POWER SWITCH [POWER] (p. 31) t HEADPHONE JACK [PHONES] ➥ Push to turn ON the transceiver power. Plug in standard stereo headphones (impedance: 8 • First, confirm the DC power source is turned ON. to 16 ø). ➥ Hold down for 1 second to turn OFF the power. • Output power: More than 5 mW with an 8 ø load. w TRANSMIT SWITCH [TRANSMIT] (p. 46) • When headphones are connected, the internal speaker, and any external speaker, are disabled. Push to select transmit or receive. • T he MAIN and SUB Band audio can be mixed or sepa- • While transmitting, the MAIN Band's TX/RX indica- rated when using stereo headphones, depending on the tor (i) lights red. Only on the satellite mode, the SUB "Phone Separate" option in the Set mode. (p. 166) Band's TX/RX indicator (!6) lights red. • While receiving or when the squelch opens, the indica- y ELECTRONIC KEYER JACK [ELEC-KEY] tor lights green. Plug in a bug or paddle type key to use the internal e ANTENNA TUNER SWITCH [TUNER] (p. 159) (Frequency band: HF/50 MHz) electronic keyer for CW operation. (p. 22) • Set the keyer type to ELEC-KEY, BUG KEY or Straight key in the "Keyer Type" item of the Keyer Set mode. ➥ P ush to turn the internal antenna tuner ON or • When a straight key is connected, "Straight key" must OFF (bypass). be selected in the "Keyer Type" item of the Keyer Set • " " appears when the tuner is turned ON. mode. (p. 55) • The internal antenna tuner settings can be memo- • A straight key jack is located on the rear panel. See rized in each frequency band. [KEY] on pages 11 and 22. ➥ Hold down for 1 second to manually start the an- • Y ou can reverse the keyer paddle polarity (dot and tenna tuner. • If the tuner cannot tune the antenna within 20 sec- onds, the tuning circuit is automatically bypassed. dash) in the "Paddle Polarity" item of the Keyer Set mode. (p. 55) • Four keyer memory channels are available for your convenience. (p. 51) r A NTENNA•METER SWITCH [ANT•METER] (dot) ANTENNA SWITCH Operation (p. 158) (com) (Frequency band: HF/50 MHz) (dash) ➥ Push to select either the ANT1 or ANT2 connec- tor. u MICROPHONE CONNECTOR [MIC] METER SWITCH Operation (p. 45) (Frequency band: ALL) ➥ Hold down for 1 second to toggle the transmit Plug in the supplied or an optional microphone. • See page 199 for appropriate microphones. • See page 30 for microphone connector information. meter function between ALC, COMP and SWR. i MAIN BAND TX/RX INDICATOR ➥ Lights green when the squelch opens, or a signal is received on the MAIN Band; lights red during transmit. ➥ B links green when an off-frequency signal is re- ceived, depending on the "FM/DV Center Error" 1 option in the Set mode. (p. 162)