Icom IC-9100 Instruction Manual - Page 16

1 PANEL DESCRIPTION ■ Front panel (continued) #8 #9$0 $1 $2 $3 $4 $5 $6 $7 $8 $9 %0 #8 VFO/MEMORY SWITCH [VFO/MEMO] ➥ Push to switch between the VFO and memory modes. (pp. 34, 139) ➥ Hold down for 1 second to copy the memory contents to the displayed VFO on the MAIN Band. (p. 142) #9 MEMO PAD-WRITE SWITCH [MP-W] (p. 144) Push to write the displayed data into a memo pad. • The 5 most recent entries remain in the memo pads. • The memo pad capacity can be extended from 5 to 10 in the "Memopad Numbers" item of the Set mode. (p. 164) $0 MEMORY WRITE SWITCH [MW] (p. 140) Hold down for 1 second to store VFO data into the selected memory channel. • This can be done in both the VFO and memory modes. $1 MEMO PAD-READ SWITCH [MP-R] (p. 144) Push to sequentially call up the contents from the memo pads. The 5 (or 10) most recently programmed frequen- cies and operating modes can be recalled, starting from the most recent. • The memo pad capacity can be increased from 5 to 10 in the "Memopad Numbers" item of the Set mode. (p. 164) $2 MEMORY CLEAR SWITCH [M-CLR] (p. 141) In the Memory mode, hold down for 1 second to clear the memory channel. • The channel becomes a blank channel. • This switch is disabled in the VFO mode. $3 T UNING STEP•REPEATER GROUP SWITCH [TS•GRP] TUNING STEP SWITCH Operation (p. 38) ➥ Push to toggle between the kHz and MHz* quick tuning step, or turn OFF the quick tuning. * When the HF/50 MHz frequency band is selected, MHz step cannot be selected. • When the "Z" quick tuning icon is displayed above the kHz or MHz digit, the frequency is changed in programmed quick tuning steps or 1 MHz steps. • When the quick tuning is OFF, the frequency is changed in 10 Hz steps. ➥ When the quick tuning is ON, hold down for 1 second to display the "TS" screen (Tuning Step) to select the quick tuning step. (p. 38) • 0.1, 1, 5, 6.25, 9, 10, 12.5, 20, 25, 50 and 100 kHz steps are independently selectable for each operating mode. ➥ When the quick tuning is OFF, hold down for 1 second to turn the minimum tuning step of 1 Hz ON or OFF. (p. 39) CALL SIGN GROUP SWITCH Operation (p. 93) (Mode: DV) (Only when " " is displayed.) ➥ Push to switch the call sign group. ➥ Hold down for 1 second to enter the repeater call sign group selection mode. • "≈" blinks. ➥ When in the repeater group selection mode, push to cancel it. 7