Icom IC-9100 Instruction Manual - Page 183
Option Installation
View all Icom IC-9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
16 OPTION INSTALLATION ■ Opening the transceiver's case Icom strongly suggests that the customer have their dealer or Icom distributor, for a reasonable fee, install Icom options at the time of the order. Icom understands that even the simplest of installations demands the judgment of a trained Icom technician. Therefore, Icom will not be responsible for damage to the optional unit, or subsequent damage to the transceiver due to user installation problems. The option's or the transceiver's Warranty can be voided in such situations, at the sole judgment of Icom. The following are instructions for removing the covers of the IC-9100. R WARNING! Turn OFF the power and disconnect the DC power cable from the transceiver before performing any work on the transceiver. Otherwise, there is danger of electric shock and/or equipment damage. q R emove the two screws from the carrying handle and remove it from the transceiver. For those customers who still wish to install their own options, knowing the risks and possible consequences, the following information is provided for information purposes only. Top Rear Front Bottom w R emove the six screws from the top of the transceiver and the six screws from the sides, then lift up the top cover. e Turn the transceiver upside-down. CAUTION: NEVER HOLD THE UNIT BY THE MAIN DIAL OR ANY OTHER KNOBS when you turn the transceiver upside down. This may damage them, or cause you to drop the transceiver. r R emove the six screws from the bottom, and then lift off the bottom cover. ✔ About the leg pads To detach the leg pads from the right side panel of the top/bottom cover, push them out from the inside of each cover, after completing steps q through r above. NOTE: If the thermal sheet on the bottom cover is detached, reattach it in its original position, as illustrated to the right. The surface of the thermal sheet is sticky, so push it into place, as illustrated to the right. If the surface of the thermal sheet is dusty, and does not adhere, clean its surface with water, and dry it well before reattaching. Carrying handle Top cover PA shielding plate Bottom cover Bottom cover Thermal sheet Reattach the thermal sheet, making sure it is within the marked area on the bottom cover. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 174