Icom IC-9100 Instruction Manual - Page 55
Basic transmit operation - hf vhf uhf transceiver
View all Icom IC-9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
3 BASIC OPERATION ■ Basic transmit operation Before transmitting, monitor the operating frequency to make sure transmitting won't cause interference to other stations on the same frequency. It's good amateur practice to listen first, and then, even if nothing is heard, ask "Is the frequency in use?" once or twice, before you begin operating on that frequency. D Transmitting CAUTION: Transmitting without an antenna may damage the transceiver. In the AM mode, you can transmit on only the HF/50MHz frequency bands. q P ush [PTT] on the microphone to transmit. (or [TRANSMIT] on the transceiver) • The MAIN Band TX/RX indicator lights red. • When in the satellite mode, the SUB Band TX/RX indicator lights red. (p. 156) w R elease [PTT] again to receive. (or push [TRANSMIT]) ✔ Adjusting the transmit output power ➥ Rotate [RF POWER]. Decreases Increases Frequency band RF output power range HF/50 MHz 2 to 100 W (AM: 2 to 30 W) 144 MHz 2 to 100 W 430 MHz 2 to 75 W 1200 MHz 1 to 10 W D Microphone gain adjustment (Mode: SSB/AM/FM/DV) q P ush [PTT] to transmit. • Speak into the microphone at your normal voice level. w In the SSB mode: Hold down [ANT•METER] for 1 second to select the ALC meter. And then, while speaking into the microphone, rotate [MIC GAIN] so that the ALC meter reading stays within the ALC zone. In the AM, FM and DV modes: While speaking into the microphone, rotate [MIC GAIN] with another station listening to your voice for clarity. Recommended level for Icom microphones Decreases Increases e R elease [PTT] to receive. [TRANSMIT] MAIN Band TX/RX indicator 1 2 3 [RF POWER] SUB Band TX/RX indicator 4 NOTE: When you transmit on the HF/50 MHz fre- 5 quency bands, while monitoring an out of the ama- teur band frequency on VHF or UHF on the SUB 6 band, the squelch on the SUB Band closes. There- fore, you cannot receive on the VHF or UHF fre- 7 quency. 8 9 10 11 12 13 [ANT•METER] 14 15 16 17 [MIC GAIN] 18 19 ALC zone 20 21 46