Icom IC-9100 Instruction Manual - Page 18

1 PANEL DESCRIPTION ■ Front panel (continued) %1 %2 %3 %4 %1 MAIN DIAL (pp. 37, 161) Rotate to change the displayed frequency, select the Set mode settings, etc. When the SUB Band setting mode is ON, rotating [MAIN DIAL] changes the SUB Band frequency. (p. 33) %2 CLEAR SWITCH [CLEAR] (pp. 69, 81) Hold down for 1 second* to clear the RIT/∂TX shift frequency. * When the "Quick RIT Clear" item in the Set mode is ON, push momentarily to reset the shift frequency. (p. 164) %3 RIT/∂TX CONTROL [RIT/∂TX] (pp. 69, 81) When either or both the RIT/∂TX functions are ON, rotate to adjust the RIT/∂TX frequency shift. • Rotate the control clockwise to increase the frequency, or counterclockwise to decrease the frequency. • The frequency shift range is ±9.99 kHz in 10 Hz steps. The control tunes in 1 Hz steps when the operating frequency readout is set to the 1 Hz step readout. However, the 1 Hz digit is not displayed on the frequency shift readout. Shift high %4 SPEECH/LOCK SWITCH [SPEECH/LOCK] SPEECH SWITCH Operation (p. 45) ➥ P ush to audibly announce the S-meter level, the displayed frequency and the operating mode. • The S-Level announcement can be turned OFF in the "SPEECH S-Level" item of the Set mode. (p. 164) • W hen RIT and/or ∂TX are ON, the RIT/∂TX offset is not included in the frequency announcement. LOCK SWITCH Operation (p. 77) ➥ H old down for 1 second to turn the Dial Lock function ON or OFF. • T he function electronically locks the Main dial. • " " appears when the function is ON. NOTE: The [SPEECH/LOCK] switch operation to activate the voice synthesizer or the dial lock functions can be replaced in the "[SPEECH/ LOCK] SW" item of the Set mode. (p. 164) Shift low 9