Icom IC-9100 Instruction Manual - Page 50

3 BASIC OPERATION ■ Frequency setting (Continued) D Band edge warning beep You can hear a beep tone when you tune into or out of an amateur band's frequency range. A regular beep sounds when you tune into a range, and an lower tone error beep sounds when you tune out of a range. q H old down [MENU] for 1 second to enter the Set mode. w P ush [Y](F-1) or [Z](F-2) to select "Band Edge Beep." e R otate [MAIN DIAL] to select the desired band edge warning beep setting. • OFF : Band edge beep is OFF. • ON (Default) : W hen you tune into or out of the default amateur band's fre- quency range, a beep sounds. (default) • ON (User) : W hen you tune into or out of a user programmed amateur band's frequency range, a beep sounds. • ON (User) & TX : W hen you tune into or out of a user programmed amateur band's frequency range, a beep sounds. Also transmission is in- hibited outside the programmed range. • Hold down [F-3] for 1 second to reset to the default value. r Push [MENU] to save, and exit the Set mode. The beep output level can be set in the "Beep Level" item of the Set mode. (p. 161) About the user band edge frequencies When "ON (User)" or "ON (User) & TX" is selected in the "Band Edge Beep" item, a total of 30 band edge frequencies can be programmed in the "User Band Edge" item. See the next page for details. If "OFF" or "ON (Default)" is selected, the "User Band Edge" item does not appear in the Set mode. [∫] [√] [MENU] [MAIN DIAL] SET B a n d E d g e B e e p Ù 6Ú ON(Default) ON (Default) SET B a n d E d g e B e e p Ù 6Ú ON(User) ON (User) selection Push SET U s e r B a n d E d g e Ù 7Ú DEF EDT [User Band Edge] item 41