Icom IC-9100 Instruction Manual - Page 176

14 SET MODE ■ Set mode description (Continued) 54. External Keypad (Default: OFF) Turn the external keypad ON or OFF for keyer memory transmission. See page 26 for the equivalent circuit of an external keypad and connection. • OFF : The external keypad does not func- tion. • KEYER SEND : In the CW mode, pushing one of ex- ternal keypad switches transmits the desired keyer memory contents. 55. USB Audio SQL (Default: OFF(OPEN)) Select whether or not to output the audio from the [USB] connector on the rear panel, according to the squelch state. The same audio signals are sent from the [USB] connector and the [ACC] sockets. - The beep tones and the voice synthesizer announce- ments are not sent. - The received audio output level cannot be adjusted with the [AF] control. • OFF (OPEN) : The received audio is always sent, regardless of the squelch state. • ON : T he received audio is sent when the squelch is open. 56. USB MOD Level (Default: 50%) Set the input modulation level of the [USB] connector to between 0% and 100% in 1% steps. 57. 9600bps Mode (Default: OFF) Turn the [DATA2] socket's 9600 bps data transmission ON or OFF. • OFF : F or only the regular audio (or slow data) transmission. • ON : For 9600 bps data transmission. 58. DATA OFF MOD (Default: MIC,ACC) Select the desired connector(s) for data modulation input in the data OFF mode. • MIC : Use the signals from [MIC]. • ACC : Use the signals from [ACC] (pin 11). • MIC, ACC : U se the signals from [MIC] and [ACC] (pin 11). • USB : Use the signals from [USB]. 59. DATA MOD (Default: ACC) Select the desired connector(s) for data modulation input in the data mode. • MIC : Use the signals from [MIC]. • ACC : Use the signals from [ACC] (pin 11). • MIC, ACC : Use the signals from [MIC] and [ACC] (pin 11). • USB : Use the signals from [USB]. 60. CI-V Baud Rate (Default: Auto) Set the CI-V data transfer rate between 300, 1200, 4800, 9600, 19200 bps and "Auto." When "Auto" is selected, the baud rate is automatically set according to the data rate of the connected controller. 61. CI-V Address (Default: 7Ch) To distinguish equipment, each CI-V transceiver has its own Icom standard address in hexadecimal code. The IC-9100's address is 7Ch. When 2 or more IC-9100's are connected to an optional CT-17 ci-v level converter, rotate [MAIN DIAL] to select a different address for each IC-9100; the range is 01h to DFh. 62. CI-V Transceive (Default: ON) Turn the transceive function using the CI-V system ON or OFF. When this item is set to ON, changing the frequency, operating mode, etc. on the IC-9100 automatically changes those settings on other Icom transceivers or receivers, and vice versa. • OFF : Transceive function OFF • ON : Transceive function ON 63. USB2/DATA1 Func (Default: [-----]/GPS) Two COM port numbers are assigned to the [USB] connector. One of them is "USB1," used for cloning and CI-V operation. The other one is "USB2," and the function is selected by this item. USB2" is not used. • RTTY : Used to send RTTY decoded signals. • DVdat : Used for low-speed data input and output. • If you set the function of the [DATA1] jack to "GPS," and "DATA1 ➔ USB2" is selected as the "GPS Out" item's option, as described below, "USB2" will be used for the low-speed data input and GPS data output. 167