Icom IC-9100 Instruction Manual - Page 112

8 DV MODE OPERATION ■ Calling a specific station This section describes how to call a specific station using the DR mode. When the Link repeater (R2) is set to "GW," the designated gateway repeater is automatically set as the Link repeater, and you can make a call to a specific station through the internet. q S et your own call sign. w H old down [DV•DR] for 1 second to select the DR mode. • T he last used access repeater is displayed. - If the displayed frequency band on the SUB Band is the same as that of the last used access repeater, selecting the DR mode on the MAIN Band will automatically move the frequency band on the SUB Band to the Main Band display, and turn OFF the SUB Band display. e R otate [MAIN DIAL] to select the desired access repeater. • Only the repeaters, whose "R1USE" setting is set to YES, or Access repeater scan targets are displayed. (pp. 90, 100) r P ush [UR](F-4) to enter the UR call sign selection mode. t R otate [MAIN DIAL] to select a individual station call sign. • First selecting the station call sign memory groups (U01-U99) by pushing [TS•GRP] makes it more convenient. y H old down [UR](F-4) for 1 second to enter the Link/ Gateway repeater (R2) selection mode. Making a call to an individual station through your local area (access) repeater (Local Area call) Zone q w e r Area MY call signɿ Station call signɿ Repeater qɿNARA43 JA3YUA JG3YMK (JP3YHL) u R otate [MAIN DIAL] to select "NOT USE✱." i P ush [UR](F-4) to exit the Link repeater (R2) selec- tion mode. o P ush [PTT] on the microphone to transmit. (or [TRANSMIT] on the transceiver) • The MAIN Band TX/RX indicator lights red. !0 R elease [PTT] to receive. (or push [TRANSMIT] again) If you want to save this temporary setting, push [MW] to enter the memory select write mode. (p. 102) [UR] [TS•GRP] [DV•DR] [MAIN DIAL] [TRANSMIT] [UR] [MW] MAIN Band TX/RX indicator [MAIN DIAL] D1 R 2: N O T U S E � CS CD R>CS UR NOT USE✱ DSET 103