Icom IC-9100 Instruction Manual - Page 170
Set Mode
View all Icom IC-9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
14 SET MODE ■ Set mode description The Set mode is used for programming infrequently changed values or functions. D The Set mode settings q H old down [MENU] for 1 second to enter the Set mode. w P ush [Y](F-1) or [Z](F-2) to select the desired item. e R otate [MAIN DIAL] to select the desired option. • Hold down [F-3] for 1 second to reset to the default setting, if desired. r P ush [MENU] to save, and exit the Set mode. [∫] [√] [MENU] [F-3] [MAIN DIAL] Displays the Set mode item name and number Displays the option SET L C D C o n t r a s t Ù 1Ú 50% 1. LCD Contrast (Default: 50%) Adjust the LCD contrast to between 0% and 100% in 1% steps. 2. LCD Backlight (Default: 50%) Adjust the LCD backlight brightness to between 0% and 100% in 1% steps. NOTE: Regardless of this setting, the LCD backlight brightness is maximum (100%) at power ON by design. (It is not an equipment malfunction.) Then, the brightness level automatically returns to the adjusted value. 3. Beep Level (Default: 50%) Adjust the confirmation and band edge beep tones output level to between 0% and 100% in 1% steps. 4. Beep Level Limit (Default: ON) Turn the confirmation and band edge beep tones output level limiting ON or OFF. When you set this item to ON, the beep tones are adjusted by the [AF] control until rotating the [AF] control reaches to the specified level. Further rotation will not increase the volume of the beep tones. • OFF : Beep level adjustment is not limited. • ON : Beep level adjustment is limited with the [AF] control. Select the item Reset to the default setting 5. Beep (Default: ON) Turn the confirmation beep ON or OFF. Set the beep output level in the "Beep Level" item as described to the left. • OFF : The confirmation beep is OFF. (Silent operation) • ON : The confirmation beep sounds each time a switch is pushed. 6. Band Edge Beep (Default: ON(Default)) When you tune into or out of an amateur band's frequency range, you can hear a beep tone. If you select "ON (User)" or "ON (User) & TX," you can program a total of 30 band edge frequencies in the "User band Edge" item. You can set the beep output level in the "Beep Level" item as described to the left. • OFF : Band edge beep is OFF • ON (Default) : When you tune into or out of the default amateur band's frequency range, a beep sounds. • ON (User) : When you tune into or out of a user programmed amateur band's fre- quency range, a beep sounds. • ON (User) & TX : When you tune into or out of a user programmed amateur band's fre- quency range, a beep sounds. In addition, transmission is inhibited outside the programmed range. 161