Intel SR2400SYSD2 User Guide - Page 114
Installing a Tape Drive, Safety, Information, Removing the Chassis Cover., Removing the Front Bezel.
UPC - 735858169172
View all Intel SR2400SYSD2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Installing a Tape Drive To install a tape drive into your Server Chassis SR2400/SR2400DC, your system must meet the following requirements: ⎯ You must purchase the tape drive kit, order number ADRTAPEKIT. ⎯ You must purchase a 3.5-inch SCSI tape drive. ⎯ You must have either the SATA or SCSI backplane installed. After purchasing the tape drive kit and the tape drive, use the instructions below to install them. In addition to these instructions, refer to the instructions that came with your tape drive for additional requirements. 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information." 2. Power down the server and unplug all peripheral devices and the AC power cable or DC external source. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover." 4. Remove the front bezel. For instructions, see "Removing the Front Bezel." 5. Push the tape drive filler panel from the chassis by using a long screwdriver to push it out from the inside of the chassis. See the figure below to locate the tape drive filler panel. TP01355 Figure 80. Removing the Tape Drive Bay Filler Panel 90