Intel SR2400SYSD2 User Guide - Page 69
Safety, Information., Removing the Chassis Cover., Removing the Front Bezel.,
UPC - 735858169172
View all Intel SR2400SYSD2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Hardware Installations and Upgrades 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information." 2. Power down the server and unplug all peripheral devices and the AC power cable or DC external source. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover." 4. Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel." 5. Align the two holes at the left side of the floppy drive with the two cutouts in the floppy drive carrier. See letter "A" in the figure below. 6. Lower the right side of the floppy drive into the carrier until it clicks into place. See letter "B" in the figure below. A B TP01082 Figure 39. Installing a Floppy Drive into the Slimline Carrier 7. Open the connector on the rear of the floppy drive by pulling up on the connector cover. See letter "A" in the figure below. 8. Insert one end of the 26-pin floppy drive flat flex cable end into the connector. See letter "B" in the figure. 9. Push down on the connector cover to lock the cable into place. See letter "C" in the figure. C A B Intel® Server Chassis SR2400/SR2400DC User Guide TP01144 45